Category: GETTING STARTED
-
Getting Started: Building Your First Case in Xpfe
January 16, 2017
This webinar describes the capabilities of Xpfe, the plate-fin heat exchanger simulation program added in Version 7 of Xchanger Suite. Using the details outlined in this handout, you will be able to input process specifications and run an example case in Xpfe....
Visit
-
Getting Started: Building Your First Case in Xfh Ultra
June 19, 2018
Are you ready to build your first case in Xfh Ultra? This webinar will discuss navigating the Xfh Ultra interface and identify the available options for modeling a fired heater. After the initial discussion, we will work through an example case to demonstrate how to simulate a fired heater in Xfh...
Visit
-
Getting Started: Building Your First Case in Xvib
June 06, 2019
If you’re new to Xvib, or simply need a refresher, this webinar will help you. The webinar provides an overview of how Xvib works so that you can use it to analyze the vibration potential—both fluidelastic instability and vortex shedding amplitude—of a specific tube in the bundle of a shell-and-tube heat...
Visit
-
Getting Started: Building Your First Case in Xace
June 25, 2019
Are you ready to build your first case in Xace? This webinar discusses the Xace interface, including how to navigate, use program options to model your unit, and get help. After the initial discussion on the Xace interface, the webinar works through an example, showing you how to input geometry, run...
Visit
-
Getting Started: Building Your First Case in Xist
October 10, 2019
Are you ready to build your first case in Xist? This webinar will provide an overview of the Xist interface and explain how to set up a new case with a configuration conducive to your work flow. After reviewing the required inputs for defining process conditions, physical properties and unit geometry, we will perform...
Visit
-
Getting Started: Building Your First Case in Edgeview
September 16, 2020
Edgeview® is a new software tool that analyzes heat exchanger performance across a range of operating data. It is most powerful when used in conjunction with Xist®. This webinar provides an overview of the Edgeview interface, demonstrates how to set up a case and perform an analysis, and offers guidance on the reports...
Visit
-
Getting Started: Specifying Fluid Properties in Xchanger Suite
November 19, 2020
Two important considerations in heat exchanger design and analysis with Xchanger Suite are defining a heat exchanger’s geometry and specifying fluid properties. This webinar focuses on fluid property specification. We will provide an overview of the available options in Xchanger Suite, illustrate these options using simple examples, and discuss HTRI’s recommendations and guidelines. ...
Visit